DO NOT OVERTIGHTEN #6x1”
Flathead Screws. Make sure
the screw heads are flush
with plastic.
Assembly Instructions
Auntie Sewing Machine Cabinet Page 5
Step 3. Attach the plastic brown Drawer Runners
by using #6x1” Flathead Screws (x32) to the
Partition (F) & Right Side (H) as shown In FIG. 3.
Step 4. Screw Drawer stoppers (4 total) into
Right side panel (H) above drawer runners using
#6x5/8” flathead screw (x4). DO NOT tighten the
FIG. 3
FIG. 4
screws completely, leave 1/4” for up and down
swivel of the drawer runner. Insert Metal dowel
(x4) into pre-drilled hole next to drawer stops.
#6x1”
Flathead Screw x32
DO NOT OVER TIGHTEN. If the brown plastic
around the screw holes turns white, you have over
tighten and the drawers won’t fit!
Metal Dowels x4
#8x5/16”
Flathead Screws x4
Drawer Stoppers x4
To Next Page
