Arrow NORMA JEAN 350 - Page 5

180°
Assembly Instructions
Norma Jean Sewing Machine Cabinet Page 3
Understanding How the “ARROW-LOC” Cam Fastener Works
Cabinet Assembly
Position bolt in
pre-drilled hole and
turn until tight.
Press cam Into pre-drilled
hole until flush with surface.
Insert bolt through pre-drilled
hole in edge of panel.
To lock, rotate cam
until tight, using
screwdriver.
ARROW TOWARDS
HOLE IN EDGE!
FIG. 1A
FIG. 1
Partition
(viewed from left)
Partition
(viewed from right)
Step 1. Place Top (A, B & C), Partition (F) and
Left and Right Sides (D & E) on a flat protected
surface (to prevent scratching of parts) and thread
connecting bolts (25 total) into pre-drilled holes
(as shown In FIG. 1). Turn Partition (F) over and
thread in the remaining bolts as indicated below
(FIG. 1A).
Connecting Bolts x25
A
B
C
D
E
F
F