DO NOT OVERTIGHTEN #6x1”
Flathead Screws. Make sure
the screw heads are flush
with plastic.
Assembly Instructions
Norma Jean Sewing Machine Cabinet Page 5
Step 3. Attach the plastic brown Drawer Runners
by using #6x1” Flathead Screws (x32) (as shown In
FIG. 4).
Step 4. Attach the Magnet to the Partition (F) by
using #6x5/8” Screws (x2). Be sure to keep the
magnet Strikes (metal) facing towards the front
edge of the Partition (F) (as shown In FIG. 4.).
FIG. 3
FIG. 4
Screw drawer stop (4) total into Right side panel
(E) above drawer runners using #6x5/8” flathead
screw (x4). DO NOT tighten the screws completely,
leave 1/4” for up and down swivel of the drawer
runner. Insert Metal dowel (x4) into pre-drilled
hole next to drawer stops.
#6x1”
Flathead Screw x32
DO NOT OVER TIGHTEN. If the brown plastic around
the screw holes turns white, you have over tighten
and the drawers won’t fit!
Metal Dowels x4
Door Magnet x1
#6x5/8”
Gold Panhead Screws x2
#8x5/16”
Flathead Screws x4
To Next Page
Loading...