Assembly Instructions
Norma Jean Sewing Machine Cabinet Page 6
Step 5. Attach the plastic Trays (x4) to the Door
(O) by inserting the #8x1/2” Panhead Screws
(x16) into the Door (0). The (3) smaller trays are
mounted in the three top rows of predrllled holes,
Step 6. Attach Support Hinges (x4) to Right and
Left Supports (L & K) with #7x518” Flathead
Screws (x8); Insert Round Magnets (x2) into holes
in Leaf Supports (L & K) (as shown In FIG. 6).
FIG. 5
FIG. 5A
FIG. 6
#4x1/2”
Bronze Flathead Screw x1
with larger tray mounted in bottom row. Attach
Magnet Strike Plate wtth #5x5/8” Flathead Screw
(x1).
Attach (3) Door hinges to Door (O) with #4x1/2”
Flathead Screws (x12) (as shown In FIGS. 5 and 5A).
#8x1/2”
Panhead Screws x16
#4x1/2”
Gold Flathead Screws x12
Strike Plate x1
Door Hinge x3
Note: Long Side to Door
Cover the magnet with a wood block and tap hard
to get magnet in the hole. Attach rubber tabs to
Leaf Supports (L & K), make sure and place tab on
opposite edge from round magnet!
Plastic Tray Large x1
Plastic Tray Small x3
Support Hinge x4
Round Magnet x2
Wood block
Seff Sticking
Rubber Tab x2
#7x5/8”
Flathead Screw x8
To Next Page
Loading...