4
BACK TO
INDEX
ASSEMBLY
Your TR550™ comes fully assembled
OPERATION
IMPORTANT OPERATION NOTICE
1 When first using your new Glue Gun, it will take two 4" sticks of glue to fill the melt
chamber before glue begins to flow out.Wait 3 to 5 minutes for gun to heat up.
If, when squeezing trigger, glue does not enter gun easily, do NOT continue to squeeze
trigger. Glue chamber may not be hot enough to melt glue fully.
Excessive squeezing of trigger will cause hot glue to back up and flow out of rear of
gun, possibly causing severe burns.
2 Fold support stand forward. Fold back for use.
3 Place gun on work bench. Plug into 110 volt AC
(N. & S. America) outlet. Wait 3 to 5 minutes to heat up.
4 Bead gluing
5 SNAKE PATTERN – For Cartons, Corrugated Board, Foam Board
To Next Page
Loading...
