Why does my Arrows Hobby 1100mm P-51 aircraft not respond to the throttle?
If your Arrows Hobby Toy aircraft isn't responding to the throttle but responds to other controls, it might be because the ESC isn't armed or the throttle channel is reversed. To solve this, lower the throttle stick and throttle trim to the lowest settings. Also, reverse the throttle channel on the transmitter.
What to do if my Arrows Hobby 1100mm P-51 has reduced flight time?
If you're experiencing reduced flight time or the aircraft feels underpowered, it could be due to a low flight battery charge, a backward-installed propeller, or a damaged flight battery. Try completely recharging the flight battery, ensure the propeller is installed correctly, and consider replacing the flight battery, following all battery instructions.
Why is my Arrows Hobby Toy motor losing power?
If the motor power pulses and then the motor loses power, it could be due to damage to the motor or battery, a loss of power to the aircraft, or the ESC using a default soft Low Voltage Cutoff (LVC). Check the batteries, transmitter, receiver, ESC, motor, and wiring for any damage, replacing parts as needed. Land the aircraft immediately and recharge the flight battery.
What to do if my Arrows Hobby Toy controls are reversed?
If the controls on your Arrows Hobby Toy are reversed, it means the channels are reversed in the transmitter. Perform the control direction test and adjust the controls for both the aircraft and the transmitter to correct this.
How to fix excessive vibration in my Arrows Hobby 1100mm P-51?
Excessive vibration or propeller noise in your Arrows Hobby Toy can be caused by a damaged spinner, propeller, motor, or motor mount, loose propeller and spinner parts, or a propeller installed backward. Replace any damaged parts. Tighten the parts for the propeller adapter, propeller, and spinner. Ensure the propeller is installed correctly.
What to do if Arrows Hobby 1100mm P-51 Toy control surfaces are unresponsive?
If the control surfaces on your Arrows Hobby Toy are unresponsive or sluggish, it could be due to damage to the control surface, control horn, linkage, or servo. It may also be caused by damaged wiring or loose connections. Replace or repair any damaged parts and adjust the controls. Check the connections for loose wiring.
What does it mean when the LED on my Arrows Hobby 1100mm P-51 Toy receiver flashes slowly?
A slowly flashing LED on the receiver of your Arrows Hobby Toy indicates a power loss to the receiver. Check the connection from the ESC to the receiver, inspect the servos for damage, and check the linkages for any binding.
General| Wingspan | 1100mm |
|---|---|
| Material | EPO Foam |
| ESC | 40A Brushless ESC |
| Motor | 3536-KV850 Brushless Motor |
| Battery | 11.1V 2200mAh LiPo |
| Control | 4 Channel |
| Servos | 9g x 4 |
| Propeller | 4-Blade |
| Radio System | 2.4GHz |
To Next Page
