6
OPERATION
MAXIMUM LOAD
The eight circuit breaker protected outlets are rated at 15 amps, which is equivalent to 1800 watts at
120 volts. If the total load on the 4x4 POWER DISTRIBUTION Unit's outlets (and rack lights on the
SP & PS) exceed 15 amps, the circuit breaker will trip, cutting off power to your rack. If this happens,
reduce the load by unplugging one or more units from the 4X4 POWER DISTRIBUTION UNIT. Then
push the circuit breaker button in to reset it.
LED LAMPS (SP & PS)
The 4x4 POWER DISTRIBUTION Unit's lamps pull out easily and may be aimed to provide the best
illumination for your equipment. Adjust the DIMMER control for the desired brightness. The lights do
not turn off automatically when the tubes are pushed in, so be sure to switch the RACK LIGHTS
switch to the OFF position before pushing in the tubes.
POWER SWITCHES
The 4x4 POWER DISTRIBUTION Unit's has a master POWER switch for the rear outlets as well as
the lights (SP & PS). This switch glows when the unit is on.
To Next Page
Loading...
