8
Rear Panel Controls
There is a group of ten DIP switches located towards the right end of the back panel,
when viewed from the rear. These switches are nominally all in the up or OFF position.
Their function is described below.
Rear Panel DIP Switches
MIC PHANTOM POWER Switches (1-3)
These numbered switches control the application of phantom power (+48V) to the
corresponding numbered MIC XLR connectors. In the OFF position (up), no phantom
voltage is applied. Moving the switch down (ON position) applies phantom voltage.
Note that when phantom voltage is applied, the current supplied is limited to 7 mA for
each leg of the balanced line.
To Next Page
Loading...