27
INSERTING / REPLACING THE BATTERY
AAE MODELS ONLY
To insert or replace the battery which powers the igniters:
1. Slide the drip tray forward slightly, as shown above.
2. Unscrew the battery cap (rotate counterclockwise as viewed from below).
3. Either insert a new battery or replace the old battery with a new battery.
4. Replace the battery cap (rotate clockwise as viewed from below).
5. Slide the drip tray back in place.
REMOVE CAP
REPLACE CAP
DRIP TRAY
Note:
All ART2 models have 115 V ignition. No batteries are required.
To Next Page
Loading...