Need help?Do you have a question about the ARTronic ARTon Plus series and is the answer not in the manual?
General| Input Voltage | 220/230/240VAC |
|---|---|
| Output Voltage | 220/230/240VAC |
| Topology | Line Interactive |
| Output Waveform | Simulated Sine Wave |
| Frequency Range | 50/60Hz ± 1Hz |
| Transfer Time | 2-6ms typical |
| Battery Recharge Time | 4-6 hours to 90% after complete discharge |
| Operating Temperature | 0-40°C |
| Storage Temperature | -15-45°C |
| Humidity | 0-95% relative humidity (non-condensing) |
| Dimensions | Varies by model, refer to datasheet |
| Weight | Varies by model, refer to datasheet |
Lists detailed electrical, environmental, and performance parameters for the UPS models.
Details the main controller board's functions, signal I/O, and adjustments.
Details on connecting AC input, bypass, output cables, and safety earth.
Importance and procedure for proper grounding of the UPS system.
Step-by-step guide for connecting the UPS power cables correctly.
Instructions for installing and connecting battery banks to the UPS.
Configures UPS operational settings, modes, and remote functions.
Identifies common alarms and provides basic troubleshooting steps.
Configuration for increasing total power capacity by summing UPS ratings.
Configuration for enhanced reliability, where load is shared for redundancy.
Configuration for increased reliability with spare capacity (N+1).
Step-by-step guide for operating a single UPS unit in online mode.
How to power up the UPS from a complete power-off condition.
Steps to safely shut down the UPS unit.
Procedure to switch the UPS to maintenance bypass mode.
Procedure to switch from maintenance bypass back to normal operation.
Guide for operating multiple UPS units connected in parallel.
Procedure for turning on and configuring the UPS units for parallel operation.
Steps to safely shut down a parallel UPS system.
Systematic approach to diagnosing and resolving UPS faults and errors.
To Next Page
