What to do if the overload protection device stops my ARVEN TIGER 70 1?
If the overload protection device is stopping your ARVEN Water Pump, here's what you can do: * Reduce the liquid temperature and allow time for the thermal protection to reset. * Thoroughly clean the pump. * Inspect for binding between moving and fixed parts, and check the bearing wear.
How to fix a motor that doesn't start and makes no noise on my ARVEN Water Pump?
If the motor of your ARVEN Water Pump isn't starting and there's no noise, the suggested solutions are: * If burnt-out, replace them. * Turn the shaft as indicated in the Warnings chapter (Paragraph 6.3.).
Lists the manual's availability in multiple languages for user convenience.
Identifies the product lines covered by the manual: TIGER, SKIPPER, ARVEX.
Provides manufacturer ARVEN s.r.l. contact and location information.
Lists relevant EU directives and standards for product compliance.
Key recommendations for safe and proper installation and operation.
Describes recommended applications and prohibited uses for the pumps.
Details the types of fluids that can be pumped, including limitations.
Introduces the range of technical data covered for the pumps.
Instructions for safe storage and transport to prevent damage.
Mandates that qualified personnel must perform installation and repairs.
Critical safety advice, including avoiding dry running and proper handling.
Guide for checking the motor shaft's direction of rotation.
Guidelines for connecting single-phase pumps, with or without float switches.
Requirements for protecting three-phase pumps and using float switches.
Statement on manufacturer responsibility concerning product use and documentation accuracy.
Criteria for selecting and preparing the pump installation location.
Conditions necessary for correct pump operation, including immersion and temperature.
Recommendations for hydraulic connections, pipe sizing, and float switch installation.
Safety advice for users, emphasizing child supervision and operator capabilities.
Mandates that only authorized electricians perform electrical installations.
Essential checks for mains voltage compatibility and proper grounding.
Guidance on power cable safety, dedicated circuits, and protective devices.
Method for verifying and correcting motor rotation for three-phase models.
Steps for the first operation of the pump, including troubleshooting references.
How to adjust the float switch for automatic level control.
Rules on start frequency, frost protection, and cleaning after pumping specific substances.
Information on pump maintenance and the need for skilled personnel for dismantling.
Guidelines on using original spare parts and restrictions on product modifications.
A comprehensive guide to identifying and resolving common pump operational issues.
Solutions for low flow rates and motor overload protection activation.
Information on the correct disposal of electrical and electronic equipment.
Detailed data tables for TIGER series pumps, covering electrical and performance metrics.
Detailed data tables for SKIPPER series pumps, covering electrical and performance metrics.
Detailed data tables for ARVEX and ARVEX BC series pumps, covering electrical and performance metrics.
Wiring schematic for single-phase pumps without float switch functionality.
Wiring schematic for single-phase pumps incorporating a float switch.
Wiring schematic for single-phase pumps with float switch and control box setup.
Schematics illustrating the wiring for three-phase pumps at different voltage ratings.
General| Brand | ARVEN |
|---|---|
| Model | TIGER 70 1 |
| Category | Water Pump |
| Language | English |
To Next Page
