ARXP BOX5 160DTS - User Manual

Questions and Answers

V
Valerie JohnsonAug 11, 2025
Why does my ARXP BOX5 160DTS Pressure Washer pump not reach working pressure?
- G
  George GrantAug 11, 2025
  If your ARXP Pressure Washer's pump isn't reaching working pressure, several factors could be at play. The nozzle might be worn and require replacement. The water filter could be dirty, so you should clean it. Ensure that the water supply is fully turned on. Check the tightness of hose fittings to prevent air from being sucked into the system. If there is air in the pump, switch off the appliance and repeatedly depress and release the gun trigger until the water flows steadily, then switch the appliance back on. Also, if you're drawing water from an open container, make sure the suction height is not more than 0.5 meters; reduce it if necessary.
P
pamela69Aug 17, 2025
What to do if my ARXP Pressure Washer motor fails to start?
- J
  Jeffrey MackAug 17, 2025
  If the motor of your ARXP Pressure Washer fails to start, first ensure that the plug is firmly in the socket and that the mains voltage supply is present. If the issue persists, it could be due to problems with the TSS device.
R
Ronald CarrAug 23, 2025
Why does the pump pressure drop suddenly during use with my ARXP Pressure Washer?
- I
  Isaac SmithAug 23, 2025
  If the pump pressure of your ARXP Pressure Washer drops suddenly during use, there are a few potential causes. If you're using an external tank, try connecting the appliance to the mains water supply. If the inlet water is too hot, reduce the temperature. Also, the nozzle or inlet filter might be clogged, so clean them.
M
Mary KaneAug 28, 2025
Why does my ARXP BOX5 160DTS motor buzz but fail to start?
- L
  Luke MathisAug 28, 2025
  If your ARXP Pressure Washer motor buzzes but doesn't start, the power supply voltage might be too low, so check that the voltage of the mains power supply line matches what's on the appliance's plate. Also, a voltage drop might occur due to the use of an extension cable, so verify the cable's characteristics.
J
John JonesSep 4, 2025
How to fix no detergent being sucked in by my ARXP Pressure Washer?
- R
  Robert RichardsonSep 4, 2025
  If your ARXP Pressure Washer isn't sucking in detergent, the detergent might be too dense; try diluting it with water. Alternatively, there could be deposits or a restriction in the detergent circuit; flush it with clean water and eliminate any restrictions.