AS MOTOR Allmaher AS 63 2T

Questions and Answers

J
Jonathan BarkerAug 13, 2025
How to troubleshoot a starting problem in my AS MOTOR Trimmer?
- S
  Shawn ThomasAug 14, 2025
  If the AS MOTOR Trimmer engine doesn't start, several factors could be at play. First, ensure the accelerator lever is set to 'idle speed'. Check that the fuel valve is open (open both if there are two). The tank ventilation screw should also be open. Refill the fuel tank if it's empty. If the choke is open, close it. Make sure the spark plug connector is securely attached. If the engine is flooded from too many start attempts, remove the spark plug, close the fuel valve, start the engine several times to dry it out, and then reattach the spark plug. A dirty air filter can also prevent starting, so maintain the air filter. Inspect the spark plug for soot, damage, or an incorrect electrode gap; clean or replace it as needed. Finally, ensure you're using the correct spark plug connector.
L
Larry CrawfordAug 17, 2025
Why does my AS MOTOR Allmaher AS 63 2T Trimmer engine start badly?
- K
  Kevin LewisAug 17, 2025
  If your AS MOTOR Trimmer engine starts poorly or runs irregularly, begin by opening the choke. A dirty air filter can cause this issue, so maintain it. Always use fresh fuel. Check the spark plug for soot, damage, or an incorrect electrode gap; clean or replace it if necessary. Ensure that you are using the specified spark plug connector.
P
philliphansenAug 21, 2025
What to do if AS MOTOR Allmaher AS 63 2T Trimmer leaves an uneven cut?
- E
  Edward MartinezAug 21, 2025
  If your AS MOTOR Trimmer is leaving an uneven cut and your lawn looks unsightly, the blade may be dull or worn, have it resharpened or replaced. The speed may be too high for the cutting height; reduce the speed and select the correct cutting height. Clean the housing of the mower if it's heavily contaminated. Also, check the tire pressure.
J
Jonathan DiazAug 25, 2025
Why is my AS MOTOR Trimmer engine smoking?
- D
  davisjasminAug 25, 2025
  If your AS MOTOR Trimmer engine is smoking, the air filter may be soiled or drenched with oil. Maintain or replace the air filter.
W
William BraunAug 28, 2025
What causes the discharge channel to jam on an AS MOTOR Allmaher AS 63 2T Trimmer?
- R
  Robert FisherAug 28, 2025
  If the discharge channel of your AS MOTOR Trimmer is jammed, it might be because the mowed grass was too long or too damp. Adjust the cutting height and mowing speed to suit the mowing conditions.
J
Jake FloresSep 2, 2025
How to improve mulching with high plant material on AS MOTOR Allmaher AS 63 2T?
- S
  Samantha StewartSep 2, 2025
  If the mulching result with high plant material is not satisfactory when using your AS MOTOR Trimmer, reduce the speed.
A
austinmichaelSep 5, 2025
What to do if AS MOTOR Trimmer engine won't switch off?
- C
  Courtney BergSep 5, 2025
  If the engine of your AS MOTOR Trimmer does not switch off, close the fuel valve.
X
xjonesSep 9, 2025
How to improve mulching with low plant material on AS MOTOR Allmaher AS 63 2T Trimmer?
- A
  Alan ThompsonSep 9, 2025
  If the mulching result with low plant material is not satisfactory when using your AS MOTOR Trimmer, increase speed because plant material is ejected too quickly.

Summary

Notes on the Operating Manual

Intended Use of the Device

Contact and Support Information

Troubleshooting Guide

Technical Specifications and Declarations

Fuel Mixing Ratios

Accessories

Understanding Safety Symbols

Symbols in the Instructions

Explains symbols used in the manual for dangers.

Symbols on the Device

Explains symbols found directly on the device for user attention.

Device Identification and Overview

Essential Safety Instructions

User Information and Restrictions

Emphasizes reading instructions, user limitations, and operating conditions.

Safe Fuel Handling Practices

Provides guidelines for safe refueling and fuel storage.

Pre-Operation Checks and Safety Zones

Device Pre-Use Inspection

Details checks before operating the device for safety and function.

Danger Area and Fire Safety

Defines the hazardous zone and outlines fire safety measures.

Operational Safety Guidelines

Starting Engine and Blade Safety

Warns about hazards during engine start and blade operation.

Mowing Preparation and PPE

Covers clearing the area, personal protective equipment, and safe mowing.

Mowing Cautionary Advice

Slope Mowing and Fire Prevention

Safety advice for slopes and preventing fire hazards during mowing.

Vibration Awareness

Post-Operation and Maintenance Safety

Completing Work and Shutdown Procedures

Steps to follow after mowing and before storage.

Maintenance and Repair Safety Rules

Safety precautions for carrying out maintenance and repairs.

Device Component Overview

Handlebar and Control Levers

Identifies handlebar controls like drive, brake, accelerator, and vario levers.

Key Operational Components

Identifies engine start, fuel, choke, air filter, and cutting height adjustment mechanisms.

Control Element Functions

Handlebar Controls: Drive, Brake, Vario

Details operation of drive, brake, and vario levers on the handlebar.

Blade Clutch and Engine Speed Controls

Explains the function of the blade clutch and accelerator levers.

Handlebar Lateral Adjustment

Describes the mechanism for adjusting the handlebar side-to-side.

2-Stroke Specific Controls

Carburetor Choke and Tickler Use

Explains the choke and tickler for cold starts on 2-stroke engines.

Fuel Valve Operation

Describes the function and use of the fuel valves.

Mowing Best Practices

Pre-Mowing Checks and Advice

Lists checks and advice before starting mowing operations.

2-Stroke Fuel Requirements

4-Stroke Engine Care and Fueling

Fuel Usage and Oil Level Check

Specifies fuel for 4-stroke engines and the importance of checking oil levels.

Fueling the Device

Cutting Height Adjustment

Cutting Height Adjustment Details

Front and Rear Axle Height Settings

Details cutting height adjustments for front and rear axles.

Front Wheel Steering Lock

Locking and Releasing Front Wheels

Instructions for locking and unlocking the steerable front wheels.

Engine Starting Procedures

Starting 2-Stroke Engine

Step-by-step guide to start 2-stroke engines.

Starting 4-Stroke Engine (with;without Choke)

Steps to start 4-stroke engines, with and without choke.

Blade Engagement and Disengagement

Explains how to engage and disengage the cutting blade.

Device Driving and Maneuvering

Driving Operations and Speed Control

How to engage drive, adjust speed, and drive downhill.

Turning and Pushing Techniques

Instructions for turning the device and pushing it.

Switching Off and Parking Safely

Transporting the Device Safely

Transport Configuration 1 Details

Details securing the device in the first transport configuration.

Transport Configuration 2 Details

Details securing the device in the second transport configuration.

Loading and Unloading Procedures

Safe Device Loading onto Vehicle

Steps for safely loading the device onto a vehicle using ramps.

Safe Device Unloading from Vehicle

Instructions for safely unloading the device from a vehicle.

Maintenance and Cleaning Procedures

Preparation and Cleaning Steps

Steps for preparing the device for maintenance and thorough cleaning instructions.

General Inspection and Transmission Check

Regular checks of nuts, bolts, connections, and transmission for safety and condition.

Drive System and Parking Brake Checks

Checking and Adjusting the Drive

Steps to check and re-adjust the drive system for proper function.

Parking Brake Verification

How to verify the parking brake is functioning correctly.

Lubrication Points

Blade Inspection and Replacement

Blade Wear and Damage Checks

How to check the blade for wear, damage, and cracks.

Blade Clutch Function Test

How to test the function of the blade clutch.

2-Stroke Engine Maintenance

Engine Care and Spark Plugs

General engine care and spark plug maintenance for 2-stroke engines.

Air Filter Maintenance

Procedure for cleaning and replacing the air filter.

4-Stroke Engine Maintenance

Engine Oil and Spark Plug Checks

Checking oil level and maintaining spark plugs for 4-stroke engines.

Air Filter Maintenance (4-Stroke)

Procedure for maintaining the air filter on 4-stroke engines.

Device Assembly and Setup

Scope of Delivery and Unpacking

Lists included items and steps for unpacking the device.

Unfolding Device Components

Instructions for unfolding the handlebar, protective bow, and height adjustment cranks.

Device Storage and Restarting

Storage Procedures and Longer Storage

Guidelines for storing the device safely and preparing for extended periods.

Spare and Wear Parts

Disposal Instructions

Warranty Information

Troubleshooting Common Issues

Available Accessories

Fuel Mixing Ratios Explained

Technical Data AS 63 2 T

Technical Data 4-Stroke Devices

Declaration of Conformity