EasyManua.ls Logo

AS MOTOR Allmaher AS 63 2T ES - User Manual

AS MOTOR Allmaher AS 63 2T ES
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Operator's Manual
Allmäher®
AS624TB&S, AS632TES, AS634TB&S,
AS634THonda
From serial number: AS 62 4T B&S: 036019110001, AS 63 2T ES: 034619070001,
AS 63 4T B&S: 026917110001, AS 63 4T Honda: 027517110001
Issued: 26 November 2019, V6.0
en-Translation of the Original Operator's Manual

Table of Contents

Questions and Answers

  • K
    Kenneth CummingsAug 18, 2025
    Why is the engine of my AS MOTOR Allmaher AS 63 2T ES getting hot?
    • P
      Pamela FreemanAug 18, 2025
      If your AS MOTOR Trimmer engine is running hot, it could be due to a dirty ventilation grid. Clean the ventilation grid to resolve this. Alternatively, the cooling fins of the engine may be dirty, in which case you should have them cleaned by an authorized service center.
  • S
    Samantha RodriguezAug 21, 2025
    Why does my AS MOTOR Trimmer engine start badly?
    • M
      Matthew MorrisAug 21, 2025
      If the engine of your AS MOTOR Trimmer starts badly or runs irregularly, it could be due to several reasons: * The choke might be closed; open it. * The air filter might be dirty; maintain the air filter. * You might be using poor quality, dirty, or old fuel; always use fresh fuel. * The spark plug could be dirty, damaged, or have an incorrect electrode gap; clean the spark plug and check the electrode gap, replacing it if necessary.
  • K
    kevinleeAug 25, 2025
    Why is my AS MOTOR Allmaher AS 63 2T ES engine smoking?
    • M
      Manuel FullerAug 26, 2025
      If your AS MOTOR Trimmer engine is smoking, it could be due to a dirty or oil-drenched air filter. Maintain or replace the air filter. Another possible cause is an oil level that is too high, in which case you should have an authorized service center lower the oil level to the correct marking.
  • B
    Barbara JenningsAug 28, 2025
    How to fix uneven cuts with AS MOTOR Trimmer?
    • B
      Brandi PhillipsAug 28, 2025
      If you notice an uneven cut and the lawn becomes unsightly when using your AS MOTOR Trimmer, the blade may be dull or worn. You should have the blade resharpened and balanced by an authorized service center, and replace a damaged blade immediately. Also, the speed may be too high relative to the cutting height; reduce the speed and/or select the correct cutting height. Another cause may be a heavily contaminated mower housing; clean it. Finally, different tire pressures can also cause this issue; check the tire pressure.
  • B
    Brianna GreenAug 31, 2025
    What to do if the discharge channel of my AS MOTOR Allmaher AS 63 2T ES Trimmer is jammed?
    • C
      Carlos EvansAug 31, 2025
      If the discharge channel of your AS MOTOR Trimmer is jammed, it might be because the mowed grass was too long or too damp. Adjust the cutting height and mowing speed to suit the mowing conditions.
  • S
    Shelley ClineSep 3, 2025
    Why is my AS MOTOR Trimmer vibrating so much?
    • S
      suzannecohenSep 3, 2025
      If you experience strong vibrations during operation of your AS MOTOR Trimmer, it could be due to an imbalance of the blade caused by incorrect sharpening or chips on the blade. In this case, have the blade resharpened and balanced by an authorized service center, and replace a damaged blade immediately.
  • C
    Christy Flores MDSep 6, 2025
    Why is the mulching result with high plant material not satisfactory with my AS MOTOR Trimmer?
    • W
      Walter ThomasSep 6, 2025
      If the mulching result with high plant material is not satisfactory when using your AS MOTOR Trimmer, it could be because the speed is too high. Reduce the speed to improve the mulching result.
  • J
    James RogersSep 8, 2025
    Why is the mulching result with low plant material not satisfactory with my AS MOTOR Allmaher AS 63 2T ES Trimmer?
    • A
      April HamiltonSep 9, 2025
      If the mulching result with low plant material is not satisfactory when using your AS MOTOR Trimmer, it could be that the plant material is ejected too quickly. Increase the speed to improve the mulching result.
  • N
    Nancy ValenzuelaSep 12, 2025
    Why do the tires of my AS MOTOR Trimmer become flat?
    • L
      Laura GriffithSep 12, 2025
      If your AS MOTOR Trimmer tires become flat, it may be because thorns or sharp objects have damaged the tires. If necessary, use tire protection gel, which may be available at an authorized service center.
  • D
    Dylan WatsonNov 14, 2025
    How to fix an AS MOTOR Trimmer that won't start?
    • C
      Christopher WilliamsNov 15, 2025
      If the engine of your AS MOTOR Trimmer doesn't start, there are several potential causes: * The accelerator lever might be at “0”. In this case, turn the accelerator lever to “idle speed”. * The fuel valve could be closed. Open the fuel valve (open both if there are two). * The tank ventilation screw might be closed; open it. * The fuel tank may be empty; refill it. * The choke could be open; close it. * The spark plug connector might be pulled off; put it back on (after observing safety instructions!). * The engine might be flooded from too many start attempts. Unscrew the spark plug, start several times with the fuel valve closed, dry the spark plug, and screw it back in. * A dirty air filter can also prevent starting; maintain the air filter. * A dirty, damaged, or in...

Summary

Intended Use

Explanation of the Symbols

Warnings

Signal words indicate hazards and potential consequences: Danger, Warning, Caution, Notice.

Safety Instructions

Safe Handling of Fuel

Fuel is toxic and flammable. Keep away from ignition sources. Use gloves. Refuel outdoors when cold.

Check the Device Prior to Use

Danger Area

Driving on Slopes

Use Caution During Maintenance and Repair

Tanking Up

Check Engine Oil Level

Starting

Starting the Device (2-Stroke Device)

Place on flat surface, open fuel valve/ventilation. Plug in connector. Close choke for cold start. Press tickler. Pull starter rope.

Engaging the Blade

Lift blade clutch lever, press latch knob, press lever towards handlebar to start blade movement.

Switching Off and Parking (2 Stroke Devices)

Maintenance

Maintenance Overview

General Inspection

Checking the Parking Brake

Checking the Blade

Troubleshooting

Engine Does Not Start

Possible causes: Accelerator lever at '0', fuel valve closed, tank ventilation closed, no fuel, choke open, plug connector off, flooded engine, dirty air filter, bad spark plug, wrong connector, poor fuel.

Technical Data AS 63 2 T ES

Technical Data 4-Stroke Devices

Technical Data AS 62 4 T B&S

AS MOTOR Allmaher AS 63 2T ES Specifications

General IconGeneral
BrandAS MOTOR
ModelAllmaher AS 63 2T ES
CategoryTrimmer
LanguageEnglish

Related product manuals