ASA eSPEED B25.14/ B45.14 Instructions
For e-bikes with a Bosch drive unit
www.asa-autotechnik.de Page 15/ 18
module. Since there are slightly more disadvantages in practice from our point of view, we
have activated the manual compensation as standard.
Quick deactivation
Selecting the Off mode will deactivate the tuning until the next powering on of the ebike.
The behaviour during powering on is then oriented towards the programmed parameter of
the general tuning. As standard, it is activated again after the switching on. The stored
compensation values are also deleted during the OFF mode. This function can be
deactivated by user specific programming so that tuning is also activated during OFF
mode.
9. User-specific programming of the electronics
Programming can only occur directly after the e-bike has been switched on. If a new code
is to be entered, then the e-bike must be switched off again first.
Parameters are entered by selecting 3 modes and briefly pressing the Walk button for a
period of 2-4 seconds .
The key codes are always listed by function. Note: The Walk button at the left operating
unit must be kept pressed until you get a confirmation in the displayed speed in form of a
8. So you will get 0.8 for the acceptance of the first code, 8.8 for the acceptance of the
second code and 88.8 for the third code.
Restarting the calibration
Eco -> Walk -> Tour -> Walk -> Sport -> Walk
Note: After the calibration the e-bike should be briefly switched on and off
To Next Page
Loading...