Ascend JFD-72R - ASCEND Freezer Settings

ASCEND® Freezer Settings
Temperature set to -4 F
Parameter Function    Set Range  Default
E1  Lower Setpoint Limit   -40 F ~ set temp -10 F
E2  Higher Setpoint Limit   set temp ~ 120 F 20 F
E3  Hysteresis, temp variance  1 ~ 18 F  10 F
E4  Comp. start delay time   0 ~ 10 min.  3 min.
E5  Offset on room temp   -5 ~ 5 F   0 F
E6  Offset on evap temp   -5 ~ 5 F   0 F
F1  Max. defrost duration   1 ~ 60 min.  30 min.
F2  Defrost interval time   0 ~ 24 hr.  6 hr.
F3  Defrost termination temp  32 ~ 68 F  68 F
Key
F = Farenheit (degrees)   temp = temperature
min. = minutes    max = maximum
hr. = hours    N/A = not applicable
Warning:
Do not change the default settings of your Ascend® unit
without consulting a qualified service technician or the
Ascend® service department.
-10-
Applicable to Models: JFD-23F, JFD-48F, JFD-72F