14
S2 MAGNETIC SPINNING BIKE
STEP 6
ASSEMBLY INSTRUCTIONS
1. First, twist open and pull the L-shaped knob (9) on the frame (16) to remove
the protective post from the frame. Keep it together with the packaging.
2. Next, connect the internal cable (17) attached in the frame (16) to the cable
in the handlebar post (18).
Insert the handlebar post (18) into the frame (16), being cautious not to pinch
the cable (17). Don’t worry about the position at this stage, as you can make
adjustments according to your preferences later
To Next Page
Loading...