Before hook-up
WARNING!
Ensure that your appliance has not been
damaged during transport (broken seal or door,
etc.). If you notice any kind of damage, contact
your retailer before using the appliance. In order
to easily locate the make, model number, etc. of
your appliance, we recommend that you note
this information on the “Customer Service” page.
Electrical connections
Ensure that:
•
The electrical installation has sufficient voltage.
•
The electrical wires are in good condition.
•
The diameter of the wires complies with the
installation requirements.
•
Your electrical installation is equipped with
16-ampere thermal-sensitive protection.
In case of doubt, consult your electricianinstaller.
Electrical connections should be completed
before the appliance is placed in the wall unit.
The appliance must be recess-fitted correctly to
ensure electrical safety. During recess fitting and
maintenance operations, the appliance must be
unplugged from the socket; fuses must be cut off
or removed.
The oven must be connected with a
(standardised) power cable with three 1.5 mm
2
conductors (1 ph +1 N + ground) that must be
connected to a monophase 220-240 V network
via a IEC 60083 standardised receptacle (1 ph
+1 N + ground lead) or in accordance with
installation rules.
The safety wire (green-yellow) is connected to
the appliance’s terminal and must be
connected to the installation ground.
In the case of connections with an electric
receptacle, it must remain accessible after
installation of the appliance.
The oven’s neutral (blue wire) must be connected
to the network’s neutral. In the electrical
connection, ensure there is a means available to
the user to ensure they are able to disconnect the
appliance from the outlet, either by pulling the
plug from the outlet or by turning off a switch, in
compliance with installation rules.
If the power cable is damaged, it should be
replaced by the manufacturer, its aftersales
service department or by a qualified person to
avoid danger.
WARNING!
We cannot be held responsible for any accident
resulting from a non-existent, defective or
incorrect earth lead.
If the oven malfunctions in any way, unplug the
appliance or remove the fuse corresponding to
the sector where the oven is hooked up.
It is dangerous for anyone other than a qualified
person to perform maintenance or repair that
requires the removal of the cover providing
protection against exposure to microwave power.
5
Installing your appliance
To Next Page
Loading...