19
4 - Operations
4.1.2 KEY FUNCTIONS AND DISPLAY IN PROGRAMMING MODE
A
The parameter setting procedure
has a timeout. If no keys are
pressed for, at least 30 seconds,
the indicator switches back, auto-
matically, to the operator mode
.
After having selected the para-
meter or the code, press $
and % to display or modify
the value (see page 20).
The value is entered when the
next parameter is selected, by
pressing the R key.
Until the $ or % are
pressed or if you wait for 30 sec-
onds, the parameter value is not
inserted.
Pressing the í key, the next
group of parameters is presented
on the display.
Parameter Code/Value
Back to previous parameter
Entry key for selection
and value setting confirmation
Value modification
Access to the menu for:
Parameter setting
Configuration
J1 EN-ed3 17-02-2009 15:05 Pagina 19
To Next Page
Loading...
Need help?
General