ascon M4 series - Parameterisation Process

275..0
é 5:0
t.i.
é 5:0
p.b.
é 0
A3s.p
274.8
A.Man
O.C.
t.c.
é 1:00
t.d.
é 20
é 1:00
t.run
25
4 - Operations
4.4 PARAMETERISATION
A
The parameter setting procedure
has a timeout. If no keys are
pressed for, at least, 30 seconds,
the controller switches back, auto-
matically, to the operator mode.
After having selected the parame-
ter or the code, press $ and %
to display or modify the value (see
page 22) The value is entered when
the next parameter is selected, by
pressing the è key.
Pressing the í key, the next group
of parameters is presented on the
display.
Values
modification
Modification/
selection
enter
Prameter
menu
selection
35.0
p.b.
Parameter
value
Parameter
mnemonic
M4
Operator mode
Timer run/stop
(if option
installed)
Auto/Man
selection
(see page 24)
AL3 alarm threshold [1]
(see page 29)
Proportional band
(PID algorithm only)
0.5…999.9% of span
Integral time
(PID algorithm only)
0ff / 0.1…100.0 min
Derivative time
(PID algorithm only)
0.5…999.9% of span
Cycle time
(Time proportioning only)
1…200 sec
Overshoot control
(PID algorithm only)
0.01…1.00
Note
[1] It is not presented if the con-
troller has been configured
with alarm n° 2 not active or
of sensor break type. Digit
N/M of the configuration
code is assigned to 0 or 1.
[2] These values are not auto-
matically stored on the PID
menu parameters P.b., t.i, t.d.
M4UK.ed6 20-05-2005 11:43 Pagina 25