To Next PageTo Next Page
Need help?Do you have a question about the ascon M5 Series and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Operating Temperature | -40°C to +85°C |
| Analog Inputs | Up to 12 |
| Watchdog Timer | Yes |
| Communication Interfaces | UART, SPI, I2C |
| Analog-to-Digital Converter (ADC) | 12-bit |
| Series | M5 Series |
Information regarding electrical safety and electromagnetic compatibility requirements.
Overview of installation components, dimensions, and panel cut-out specifications.
Step-by-step instructions for instrument installation and securing.
Details of the termination unit and recommended practices for wiring.
Details on standard and low voltage power supply versions.
Configuration options for Process Variable (PV) input types like thermocouples and PT100.
Steps for configuring the controller's input parameters.
Steps for configuring setpoint selection and related parameters.
Defines the operating conditions for different alarm types.
Procedure for acknowledging alarms and start-up disabling.
Details on the Loop Break Alarm (LBA) functionality.
Parameters related to Setpoint configuration and selection.
Parameters related to alarm configuration and thresholds.
Parameters for Proportional-Integral-Derivative (PID) control.
Parameters related to the controller's tuning algorithms.
Steps for entering passwords and managing access levels.
Procedures for changing configuration and access passwords.
Overview of the programmed setpoint structure and segment types.
Description of normal, initial, and end segments, including Ramp, Dwell, Step.
Defining the maximum allowed deviation for the PV from the setpoint.
Configuration for program behavior after a power failure.
Starting and stopping programs using direct mode or parameter menu.
