OMNI 3 Quick Start User Guide Rev 3.1
OMNI
3
Quick Start User Guide
Remove the OMNI 3 Camera Head and all cables from packaging.
1. Screw the cable as indicated with the M4 screw provided. Ensure that the
cable is pulled upward during assembly.
2. When screwed in place, bend the cable so that it feeds outward.
3. Ensure that the bottom ridge * under the screw has not been covered as it
could stop the OMNI
3 Arm bracket from attaching correctly.
STEP 1: ESD Grounding Cable Assembly (Optional)
STEP 2: Mouse & Keyboard Set-Up
1. Remove USB dongle from the underside of the mouse.
2. Ensure mouse is switched to on. Ensure keyboard is switched to on.
3. Remove USB dongle from the underside of the keyboard located in the
batteries compartment.
4. Remove yellow “arrow” tab in the keyboard.
Please remove standard +5 lens before installation of +10 plan1x, +25 or +50 lens.
Also ensure the newly installed lens is selected in System settings and save to Startup
Settings.
To Next Page
Need help?
General
