10
6.3 Copy
SYSTEM-SETUP MENU:Copy
TA RGET: In 1
SOURCE: In1
6.4 Mute
IN_1:
STATUS:UNMUTE
MENU:Mute
6.5 Source
OUT_1:
1: 0.00
MENU:Source
2: OFF
3: OFF
4: OFF
1-4:
This sets the input channel source for the current output channel.
It can be used to mix the input source (in dB) or disable it (Off).
If more than one input sources are enabled, they will be added
together as the source for the current output channel.
Copy Channels from the source to the target. When the Source and Targets are both
Inputs and Outputs, all audio parameters will be copied. When one of the Source or
the Target is an input while the other is an output, only the Level, Polarity, Delay, EQ,
Crossover, and Channel Name are copied.
SOURCE:
This is the channel to be copied from.
TARGET:
This is the channel to be copied to.
6.6 Gain
IN_1: MENU:Gain
LEVEL:+15.00dB
POL :+
LEVEL:
The level (or gain) ranges from -40.00dB to +15.00dB in 0.25dB steps.
POL:
The polarity (or phase) can be normal (+) or inverted (-).
Mute or un-mute input and output channels. When an input channel
is muted, a red LED will come on for indication.
To Next Page
Loading...