Ashton Transporta - Specifications; General Specifications; Receiver Specifications; Microphone Specifications

SPECIFICATIONS:
GENERAL SPECIFICATIONS:
SPEAKER 1 X 10” Woofer & 1 x 1”
Tweeter (at 4ohm)
RECEIVER
MODULE
UHF PLL 16-channel true-
diversity single receiver
FREQ. BAND UHF 600 - 960 MHz
(801 - 825 MHz)
OUTPUT POWER 120W
CHARGE TIME 6 - 8 Hours
OPERATIVE TIME 3 - 9 Hours
RECHARGABLE
BATTERY
12V/5Ah (2 pieces)
DIMENSIONS 50cm x 32cm x 29cm (HxWxD)
WEIGHT 16kgs
RECEIVER SPECIFICATIONS:
RF RANGE UHF 801- 825Mhz
STABILITY ± 0.005%
DYNAMIC RANGE ± 40KHz w/level limiting circuit
S/N RATIO >110dB
T.H.D >105dB
SQUELCH CIRCUIT Pilotone squelch/PLL synth-
esised receiver/Non-diversity
FREQ. RESPONSE 50Hz - 18KHz (± 3dB)
RECEIVER MODE Quartz and tone squelch true
diversity/Single receiver/Non-
diversity or PLL system
WIRELESS MIC
CAPSULE TYPE
Dynamic capsule or
condenser capsule
TRANS. RATIO Approx. 10mW
MICROPHONE SPECIFICATIONS:
MIC CAPSULE Dynamic (EP-900 device ECM)
RF RANGE 600 - 960Mhz
STABILITY ± 0.005%
FREQ. RESPONSE 50Hz - 18KHz (± 3dB)
ANTENNA Built-in
S/N RATIO 80dB overall
RF OUTPUT 10mW MAX.
CURRENT
CONSUMPTION
100mA ± 10mA
BATTERY 2 x AA (1.5V)
WEIGHT 230g
PARTS LISTING:
1 x Transporta main unit
1 x Hand-held wireless microphone
1 x Bodypack receiver with lapel microphone
1 x AC power cord
4 x AA rechargeable batteries
- Page 2 -
BODYPACK SPECIFICATIONS:
RF RANGE UHF 801 - 825Mhz
STABILITY ± 0.005%
PRE-PROGRAMMED
FREQUENCY
Preset 16 Channels
ANTENNA External
WEIGHT 100g
BATTERY 2 x AA (1.5V)
TRANSPORTA.indd 5 12/04/10 3:47 PM