ASI DataMyte 600 - Page 45

Rev 3 Page 45
5. Verify the setups from the Training group are displayed. Select the Gage Suites
tab.
6. Select Add Gage Suites; select the gage suite created earlier by placing a check
mark in the box to the left of the name and select OK.
7. Verify the gage suite was successfully added and select OK.
8. Select Save changes to device to send the setups and gage suite to the 600.
Select OK to exit the collector communication interface.
9. The 600 is now ready for data collection. Disconnect the 600 from the USB cable.
10. For additional information, review Tutorial #7 – Transfer to Collector