1. Connect the serial cable—The TranSend II RCSL application uses a direct-connect cable to
establish a communications link with an ASI DataMyte data collection device.
Attach one end of the 91714 cable to the designated serial port on your PC and the other
end to the COM Port (designated by the symbol) on the data collector.
The Serial Baud Rate of the data collector must match the Serial Baud Rate of the PC
running the DataMetrics RCSL application. Once you have properly configured
DataMetrics RCSL and your data collector to communicate together and connected the
cable, you are ready to perform a transfer.
2. In the TranSend II RCSL main screen, click the Express Start icon.
The Express Start was initiated.
To Next Page
Loading...