22
Settings
Setting water hardness
If you have a dishwasher with a water softener, you may need to change the setting de-
pending on the water’s hardness level. Phone your local Water Board to check the water
hardness in your area. The dishwasher is set for low water hardness on delivery.
1. Switch off the dishwasher with the main switch.
2. Press the main switch while holding in the Start/Stop button.
3. Release both buttons and the L7 light will flash.
4. Select desired setting (see table below) by pressing repeatedly on the Program
button.
5. Confirm your selection by pressing the Start/Stop button. You now automatically leave
the settings menu and the selected setting remains until you want to change it.
Setting ˚dH ˚fH
All
extinguished
0-5* 0-9*
L1 lit
6-8 9-14
L1, L2 lit
9-14 15-25
L1, L2, L3
lit
15-19 26-34
L1, L2, L3, L4
lit
20-29 35-52
L1, L2, L3, L4,
L5, L11 lit
30-44 53-79
L1, L2, L3, L4,
L5, L6, L11, L12 lit
45 and
up
80 and
up
PROGRAM
L6
L1
L2
L3
L4
L5
L11
L12
L7
START
STOP
S1
S3
S2
S4
L8
L9
L10
*NB!
Salt dispensers are not used in Australia or
New Zealand machines.
To Next Page
Loading...
Need help?
General
