Page 7
WARNING!
Make sure you put the protective slides on the legs to
prevent damaging the floor when you slide the unit
into place (see page 6).
1. Position the machine in front of the cabinet
opening.
2. Make the height adjustment while the dishwasher
is in front of the opening.
3. Pull out the drain hose to ensure there are no sharp
bends.
4. Start to feed water and drain lines and electric cord
(if necessary) into the access hole in the cabinet.
5. Gently slide the unit into the dishwasher opening.
As you do this, feed the drain line and inlet hose
into the access hole in the side of the cabinet.
WARNING! îBe careful of sharp edges.
As you slide the unit into place, feed the drain line and
inlet hose into the access hole in the side of the cabinet.
MOVING THE MACHINE INTO PLACE
To Next Page
Loading...
