39
EMPTYING THE STEAM GENERATOR TANK
Before transporting a dryer that has been previously used, the steam generator tank must also be
emptied. Otherwise, water from the tank may spill into the dryer interior.
1
Move the dryer approximately 40 cm away from
the wall and tilt it backwards.
2
The steam generator tank discharge (emptying)
plug is located on the bottom (front left-hand side).
3
Place an empty vessel under the plug
(approximately 2 litres) and pull out the plug.
4
When the water is discharged, reinstall the plug
(if the plug is not reinstall, water will spill from the
dryer during the next drying cycle).
To Next Page
Loading...
