Asko T700 - Page 62

64
SERVICE
2
Changing the programming buttons (T700/
720)
1. Remove the panel in accordance with the sec-
tion "Panel - removing..."
2. Change the buttons.
NOTE
The buttons sit free on the push-button switches.
3. Install the panel in accordance with the sec-
tion "Panel - installation...".
Changing the main power button
1. Remove the panel in accordance with the sec-
tion "Panel - removing...".
2. Press in the latches with a screwdriver and pull
out the button.
3. Install the new button.
IMPORTANT
Ensure that the spring is located in the button
before installation.
4. Install the panel in accordance with the sec-
tion "Panel - installation...".