12
1
2
5 - START TUMBLE DRYING
Close the door and press the
Start
button.
Stopping to put in more washing
Open the door and the drum will stop automa-
tically. To restart, close the door and press the
Start
button.
6 - TUMBLE DRYING COMPLETED
Open the door and take out the washing.
7 - AFTER TUMBLE DRYING
• Turn OFF the main power switch, .
• Clean the lint filter after each tumble drying.
If the lint filter becomes clogged the overheat
protection device may trigger. The filter must
then be cleaned and the device must be reset to
enable the machine to be started, see Chapter
9, Trouble shooting.
• Empty the condensation water tank after each
tumle drying.
CLEANING THE LINT FILTER
1.Grasp the filter handle and pull towards you.
2.Pull the filter up out
of the holder.
3.Open the filter
and brush away the
lint with your hand.
4.Fold the filter together and put it back in
the filter holder.
EMPTYING THE CONDENSATION WATER TANK
Empty the condensation water tank after each
tumble drying.
Pull out the condensation water tank, empty
the water and put the tank
back.
If the tank becomes too full the program will
be interrupted. Empty the tank and press the
Start
button and the program will continue
To Next Page
Loading...
