15
1
2
CLEANING THE LINT FILTER
Clean the lint filter after each tumble drying
operation.
If your water is very hard a deposit of lime
may be formed on the filter. Check when clea-
ning lint from the filter if there is any sign of
lime, if so wash the lint filter by hand to remove
any deposits.
1.Grasp the filter handle and pull towards you.
2.Pull the filter up out of
the holder.
3.Open the filter and brush away the lint with
your hand. Rinse the filter to remove any depo-
sit of lime.
4.Fold the filter together and put it back in the
filter holder.
8 CARE - CLEANING
EMPTYING THE CONDENSATION WATER TANK
Empty the condensation water tank after each
tumble drying.
Pull out the condensation water tank, empty
the water and put the tank back.
If the tank becomes too full the program will
be interrupted. Empty the tank and press the
Start
button and the program will continue
from where it was interrupted, see also Chapter
9, Trouble shooting.
NOTE.
Do not pull out the condensation water tank
while the tumble dryer is running.
CLEANING THE OUTSIDE OF THE MACHINE
Use a mild detergent to clean the panel and the
outside of the machine. Do not use any sol-
vents, they can damage the machine. Do not
spray the machine with water.
NOTE.
Do not allow dust to accumulate round the
machine. Keep clean and cool around the tum-
ble dryer. Dust, heat and moisture prolong the
drying time.