You can choose whether the cover door is hung
on the right or the left.
Follow these instructions:
1. Remove the cover door by undoing the four
screws. The door is attached to two plastic
mounts. Pull straight out.
2. Remove the cover plates from the machine by
pushing them sideways. Whether to the right
or the left depends on how the door is fitted to
the machine.
3. Remove the door from the hinges (A). Then
unscrew the hinge from the machine (B).
4. Reattach the cover plates on the other side of
the machine.
5. Undo the screws holding the cover plates for
the steel door. Reattach them on the other
side.
6. Reattach the hinges on the other side of the
machine. Then reattach the steel door.
7. Remove the glued plastic guards from the top
edge of the cover door and move them to the
bottom edge (if the door needs to be rotated
180 degrees).
Customer Care Center32
1-800-898-1879
www.askousa.com
Reversing the door
To Next Page
Loading...
