To Next PageTo Next Page
What to do if my Asko Washer won't start?
First, ensure that the glass door is closed securely. Then, check that the power switch is turned on. If the power switch is on but the indicator lamp is not lit, there may be no power supply. Ensure the machine is properly plugged into the electrical outlet and check the house breaker switch/fuses.
What to do if my Asko W6021 has water leaks?
Inspect all hoses at least once a year and replace them if they show signs of cracking. Check hose connections at the faucets to ensure they are tight. Verify that the end of the outlet hose is securely inserted into the drain receptacle. Also, make sure nothing is caught between the Smart Seal and the tank, such as apron strings, small handkerchiefs, or socks.
What to do if my Asko W6021 will not spin?
Ensure that the pin trap or outlet hose isn’t blocked and clean if necessary. Also, make sure the No Spin option is turned off. Note that if a load is out of balance, the washer will rotate a few seconds to redistribute the load and then attempt to spin again.
What to do if my Asko W6021 has water left in the machine after the final spin?
First, make sure the No Spin option isn’t turned on. Then, check that the pin trap isn’t clogged and that the outlet hose isn’t clogged. Also, check for kinks in the outlet hose and ensure that no part of the outlet hose (including any joints) is less than 3/4” (19 mm) in diameter.
What causes oversudsing in my Asko W6021 Washer?
Too much detergent could cause suds to backup through the detergent compartment and run down the front of the washer onto the floor.
Why is my Asko Washer vibrating extremely during the spin cycle?
Ensure that all packaging and shipping supports were properly removed. Check that the machine is level. Adjust the machine feet and tighten the locknuts.
What to do if my Asko Washer stops during the cycle?
It is normal for the machine to pause occasionally during operation, especially between cycles and during the delicate wash program. Ensure that the No Spin option isn’t turned on. If the power switch is on and the indicator lamp is not lit, there is no power supply. Make sure the machine is properly plugged into the electrical outlet and check the house breaker switch/fuses.
Why is my Asko W6021 not filling with water?
Ensure that the tap to the water supply line is open. Turn off the water supply, then disconnect the inlet hose and check to see if the strainer in the inlet connection is blocked.
How to prevent rips, snags, and excess wear in my Asko Washer?
To prevent rips, snags, and excess wear: 1. Empty all pockets and turn clothes inside out before laundering. 2. Fasten all hooks, snaps, and zippers before laundering to avoid snags. Remove sharp buckles. 3. Turn knits inside out. 4. Rinse harsh chemicals from towels and other articles before washing to avoid holes in fabrics. 5. Mend all garments before laundering to prevent enlarging of rips. 6. Wash only half loads and don’t wash in the same load with heavy items, such as towels or jeans.
General| Type | Front-loading |
|---|---|
| Spin Speed | 1200 RPM |
| Energy Efficiency | A+ |
| Noise Level (Washing) | 54 dB |
| Weight | 70 kg |
| Programs | Cotton, Synthetics, Wool, Quick Wash |
| Water Consumption | 49 liters |
Instructions for sorting, powering on, loading, and adding detergents/conditioner.
Guidance on choosing programs, adjusting temperature, and spin speed.
Procedures for starting, pausing, and modifying washing cycles.
Instructions for cleaning the drain pump, detergent compartment, and machine exterior.
Guidance on cleaning the drum interior and addressing hard water deposits.
Solutions for when the machine won't start or the door won't open/close.
Step-by-step procedure for manually opening the washer door in emergencies.
Troubleshooting for issues with water intake, no spinning, or residual water.
