Asko W6021 - Page 20

Page 20
W6761 ERROR MESSAGES
Error messages will display in the LCD window if faults
occur while a program is in progress. The table below
defines each possible error message.
ERRERR
ERRERR
ERR
OR MESSAOR MESSA
OR MESSAOR MESSA
OR MESSA
GEGE
GEGE
GE
SOLSOL
SOLSOL
SOL
UTIONUTION
UTIONUTION
UTION
When this symbol flashes at the lower right corner of the display it merely means
the glass door isn’t closed securely. Close the door and try again.
0000 If this message flashes at the top right of the LCD window, the machine has failed
to spin. This could be because the load is out of balance. Turn the power off
then on again. Open the door and redistribute the washing. Run the Spin
program again.
Door lock fault Call a service technician.
Overflow Call a service technician
Pressure sensor fault Call a service technician.
Temperature stop fault Call a service technician.
Thermistor fault Call a service technician.
Wash motor fault Call a service technician.
Water inlet fault Make sure the water tap is open.
Water outlet fault Check the pin trap for possible blockage. Make sure the outlet hose isn’t kinked.
To remove the message, turn the power off or change
the program.