Asko W6231 - 7 STARTING THE PROGRAM; Interrupt the program; Alter settings during the program; 8 PROGRAM COMPLETED

14
STARTING THE PROGRAM
Close the washer door, and start the pro-
gram with the
button. It will take a
few seconds before you hear the machine star-
ting.
Interrupt the program
To interrupt the program, press the button
for three seconds. If any water remains in the
machine, run either the Drain or the Spin pro-
gram. Any water will then be pumped out. Then
press the
button to open the door. To rest-
art: fill with new detergent, if required, and se-
lect a new program.
Alter settings during the program
Press in/out the option buttons that you wish
to alter, or turn the temperature knob to the
desired setting.
- Program – the program is not affected when
the program knob is operated. Interrupt the
program instead.
- Temperature – can be altered before the tem-
perature has been reached in the main wash.
- Spin speed – can be altered at any point befo-
re the final spin.
- Super rinse – can be altered before the water
is pumped out after the main wash.
- Delayed start – cannot be altered. You should
instead interrupt the program, change the set-
tings and restart the machine.
7
7
8
8
9
9
PROGRAM COMPLETED
The program is complete when the door
can be opened with the button. If
you have selected a program without spinning,
and if water remains in the machine, run the
Spin or Drain program to enable the door to be
opened.
WHEN WASHING IS FINISHED
Turn off the main power switch and
close the washer door to prevent small
children from crawling into the machine.