18
11 TROUBLE SHOOTING
MACHINE WILL NOT START
- Is the washer door properly closed?
Press it shut firmly.
- Check that the main power switch
is ON.
- Is the power supply interrupted?
Check the fuses in the house.
Is the delayed start button pressed in?
Interrupt the program by holding in the
button for three seconds. Then press out the
button and finish by restarting with the
button.
WASHER DOOR WILL NOT CLOSE
If the door opens again immediately after you
have closed it, check that you have made the
correct program settings. If this does not help,
there is probably a fault. Call the service de-
partment.
WASHER DOOR WILL NOT OPEN
- Is the program complete?
Wait for the door mechanism to release at the
end of the program.
- Check that the main power switch
is ON.
- Is the power supply interrupted?
Check the fuses in the house. The machine door
cannot be opened with the
button if the
power supply is interrupted.
- Is water still present in the machine?
Run either of the Drain or Spin programs at a
suitable speed to remove the water.
- Emergency opening
If all else fails, emergency opening of the mach-
ine door is possible. Proceed as follows:
1. First check that there is no water in the mach-
ine. If any water remains in the machine, drain
the machine by the method described under
the heading Checking needle trap and drain
pump in Chapter 10, Care and cleaning.
2. Make certain that the main power switch is
OFF.
3. Open the drain pump cover at the bottom
left. Use the partition
piece from the liquid
detergent dispenser,
as shown in the illus-
tration.
4. Unscrew the screw holding the red plastic
handle in place.
To Next Page
Loading...
