2
Installation
Connection to water supply
Hot water connection (depending on model)
A few seconds after you start a program, the
washing machine will begin to fi ll with water from
the hot and cold supplies. If for some reason no
hot water is available, the machine waits for one
minute and then fi lls with cold water only. The
wash drum does not start to rotate until it begins
to fi ll with water.
However, if you choose to connect your ECO-
machine to cold water only, it is important that
you shut off the hot water connection.
See the "Settings" chapter for information on
how to switch between "Hot water On" and "Hot
water Off ".
Read these instructions carefully and
completely before you install themachine. The
installation should be carried out by a qualifi ed
person who is familiar with all local codes
and ordinances for electrical and plumbing
connections. Cosmetic damage must be
reported to your dealer within fi ve days from the
date of purchase. After unpacking the washer,
thoroughly check the unit for cosmetic damage.
Leveling the machine
It is important that the machine is level to
prevent excessive vibrations during spin cycles.
Each foot of the washer is adjustable, so you
can level the washer on any surface.
Once it is level, securely tighten the lock nuts
on the feet to prevent excessive vibration during
spin cycles.
Be sure to tighten the
lock nuts securely
when you level the
machine.
Water supply connection
Since ASKO washers have a built-in heating
element, you only need a cold water inlet. The
connection should be made by someone who
is suffi ciently skilled. Use the hose supplied
with the washer. (The inlet hose is marked for
correct connection.) The water pressure must
be in the range 15–146 PSI. A valve should be
fi tted on the water supply pipe. If a new supply
pipe has been installed for the washer, it should
be fl ushed thoroughly to remove any foreign
particles that might clog the fi lter in the fi ll valve.
NOTE!
If the unit is installed on a second storey, follow
local building codes. We recommend installing a
drip pan.
To Next Page
Loading...
Need help?
General
