4
Stacked installation
ASKO washers should never be stacked on a
counter or a dryer. You can, however, stack an
ASKO dryer on an ASKO washer. Refer to your
Dryer Use and Care Guide for instructions on
how to do this.
Built-in installation
ASKO washers can be installed beneath a
cabinet or worktop with a height of 34” to 35”
(863 to 889 mm) or in a closet. There must
be a gap of about ½” (12 mm) all around the
machine, including between the rear edge of
the machine’s top panel and the back wall.
The opening width must be at least 24½” (622
mm). Space must also be available for the fi ll
and drain hoses. See the illustration below for
measurements and positions. If the washer is
installed in a closet the door must be left open
while the washer is running.
If the drain outlet is higher than 24" (610 mm),
the connections will need to be recessed.
Installation
To Next Page
Loading...
Need help?
General
