WM 200
ADDITIONAL CONTROL PUSHBUTTONS
Gentle action
Can be activated with any program except Programs 8 and 11.
High water level and gentle wash action. The intermediate spin is
omitted and the program finishes with a short spin. Two rinses are
also omitted in Programs 1-3.
1/2 load
Omits the intermediate spin and two rinses. Can be used together
with Programs 1-3.
Economy
Extends the main wash by 22 minutes. Can be used together
with Programs 1-3.
The intermediate spin
Is omitted and the program finishes with a short spin. Can be used
with Programs 1-7 and 9-11.
No spin
The program finishes without pumping out. Can be used with
Programs 1-7 and 9-10.
High rinse water level
Can be used with Programs 1-3, 5-7 and 9-10.
Spin speed
Spin speed can be selected between 600 r/min and 1500 r/min in
programs with long final spins, and between 600 r/min and
800 r/min in programs with short final spins. Each press of the
button increases/decreases the speed by 100 r/min.
The machine incorporates an automatic out-of-balance feature,
which reduces the spin speed if the load is seriously out of balance.
The machine attempts to reduce the out-of-balance by stopping and
making up to 20 restarts. If the load is still out of balance, the program
continues without a spin. This is indicated by 0000 in the display.
Temperature
Starting from 40°C, which is the starting temperature for all wash
programs (1-4), each press of the button raises/lower the temperature
by 5°C, 41°F. 0° is indicated by C (cold).
Time-delayed start
Program start can be delayed by 1-12 hours. Press the button once for
each hour´s delay required. The thirteenth time the display show the
time remaining that the program in use has to run.
E
1/2
To Next Page
Loading...
