Electrical installation
If the machine is delivered from the factory with
a plug attached, it can be connected to an earthed
wall socket. Otherwise, a permanent connection
using a multipolar circuit breaker must be made
by a qualified professional.
CAUTION!
If this appliance is supplied from a cord
extensions set or electrical portable outlet
device, the cord extension ser or electrical
portable outlet device must be positioned so that
it is not subject to splashing or ingress of
moisture.
Connection on delivery
The machine is supplied as 1-Phase, 230 V, 50
Hz, heat output 3000 W and has a 16 A plug. Any
residual current devices must be type A.
NOTE!
Repairs and maintenance must be carried out
by a qualified professional.
Coin operation
The machine is prepared for coin operation. Such
installation must be carried out by a qualified
professional.
The installation requires a connection cable to
power the coin meter. This connection cable can
be ordered as an accessory using the factory art.
no. 92 090 95.
The coin meter must be able to short circuit two
signal lines for periods of up to 10 minutes. This
is to give the user time to load the machine,
choose a program and start the program after
inserting the coins.
'Insert coin' appears on the display when the
machine is started with the main power switch.
24
Installation
To Next Page
Loading...
