Need help?Do you have a question about the ASO ELMON 41-322 and is the answer not in the manual?
Illustrates a 2-wire single application setup for a safety contact edge.
Details the wiring for a 4-wire single application using the safety relay.
Presents a 2-wire multiple sensor application example with the safety relay.
Shows the wiring configuration for a 4-wire multiple sensor application.
Lists the available versions of the ELMON relay and their corresponding supply voltages.
Explains the function of the Power, CH 1, and AUX 1 LEDs and fault indication by pulse count.
Details the function and connection of each terminal on the ELMON relay.
Describes how DIP switches S1 and S2 configure the operating modes and signal outputs.
Explains the safety output configuration for separate or series-connected control circuits.
Details the automatic reset mode (S1=ON) and associated safety considerations.
Explains the manual reset mode (S1=OFF) to prevent automatic restart after faults.
Describes the RLU signaling output mode (S2=ON) with immediate activation upon fault.
Details the RL signaling output mode (S2=OFF) with delayed activation upon fault.
Details the supply voltage options (120/230V AC, 24V AC/DC) and connection terminals.
Explains how to connect sensors with or without a terminating resistor to terminals X1/X2 and X3/X4.
Describes how to connect multiple sensors in series for a sensor circuit, warning against parallel connection.
Details connecting control circuits to terminals 13/24 and factory-inserted bridges.
Explains connecting a manual reset switch to terminals Z1/Z2 for manual reset mode.
Details connecting the signaling contact (31/32) as an auxiliary contact, not for safety circuits.
To Next Page
General