-A charging animation appears when the battery is being charged. The battery light
will also appear on the front screen and will turn off when fully charged. When the
charging is complete, the animation on the main display disappears.
-Using the approved adapter:
-Install the battery into the mobile phone before charging the battery.
-Connect the cable of the approved charger with the charging port on the top of the
mobile phone. Ensure that the adapter is fully inserted.
-Insert the plug of the approved charger to an appropriate power outlet.
-During the charging, the battery level grids in the battery icon will show until the
battery is fully charged.
-The battery icon will no longer show when the charging process is complete. Charge
time is approximately 3 hours.
Note:
Ensure that the plug of the charger, and the plug of the USB cable are inserted in the
right direction. Inserting them in the wrong direction may cause charging failure or
other problems.
Before charging, ensure that the standard voltage and frequency of the local mains
supply match the rated voltage and power of the travel charger.
-Interference
The conversation quality of any mobile phone may be affected by radio interference.
An antenna is built inside the mobile phone and located near the microphone. Do not
touch the antenna area during a conversation, this will cause conversation quality to
deteriorate.
-Qualified service
Only qualified Aspera personnel or approved agent may install or repair phone
equipment. Installing or repairing the Aspera phone yourself or by unauthorised
technician may void the warranty.
-Accessories and batteries
Use only Aspera approved accessories and batteries.
-Emergency calls
Ensure the phone is switched on and in service, enter the emergency number, e.g.
000, then press the Dial key. Give your location and state your situation briefly. Do
not end the call until told to do so. The emergency number can be dialed with or
without a sim card installed.
18
To Next Page
Loading...
