10
Auto:
The software will configure the available hard disk drives to be a disk array. User can modify the hard disk drives later. It is strongly recommended
to use this method.
Custom:
Disk array is arranged by user.
2. Click “Auto” button. The “Creating Array” window will pop up. If you select “Custom”, the “Available Disks” window will list the available disk
drives for array-creating. Select a disk drive and click right arrow button to add the specific disk drive to array. After adding a disk drive, user
can also remove the selected disk drive from array. Click the disk drive in “Array Disks” windows, then click left arrow button to remove the
selected disk drive.
Press “Create” button to create or “Cancel” button to cancel it.
After you pressed the “Create” button, a warning message will pop up. Click “Yes” to finish the creation of disk array, or “No” to cancel.
3. A message box will pop up to prompt user that the disk array has been created successfully and ask user whether to restart the computer.
To Next Page
Loading...
Need help?
General
