ASROCK B550M PG Riptide - Page 47

English
41
B550M PG Riptide
Step 3
Before installing a M.2 (NGFF) SSD
module, please loosen the screws to
remove the M.2 heatsink.
*Please remove the protective lms
on the bottom side of the M.2
heatsink before you install a M.2
SSD module.
Step 4
Prepare the M.2 stando that comes
with the package. en hand tighten
the stando into the desired nut
location on the motherboard. Align
and gently insert the M.2 (NGFF)
SSD module into the M.2 slot. Please
be aware that the M.2 (NGFF) SSD
module only ts in one orientation.
en tighten the screw that comes
with the package to secure the
modules into place.
Step 5
Tighten the screw with a screwdriver
to secure the M.2 heatsink into
place. Please do not overtighten the
screw as this might damage the M.2
heatsink.
AB
20
o
AB
1
2
1
1
2
2