ASROCK FM2A88X Pro+ - Onboard Headers and Connectors

20
21
English
FM2A88X Pro+
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
USB 2.0 Headers Besides four default USB 2.0
(9-pin USB6_7)
ports on the I/O panel, there
(see p.1 No. 21)
are two USB 2.0 headers on
this motherboard. Each USB 2.0
header can support two USB
2.0 ports.
(9-pin USB8_9)
(see p.1 No. 20)
Serial ATA3 Connectors These eight Serial ATA3
(SATA_1: see p.1, No. 8)
(SATA3) connectors support
(SATA_2: see p.1, No. 7)
SATA data cables for internal
(SATA_3: see p.1, No. 19)
storage devices. The current
(SATA_4: see p.1, No. 16)
SATA3 interface allows up to
(SATA_5: see p.1, No. 18)
6.0 Gb/s data transfer rate.
(SATA_6: see p.1, No. 17)
(SATA_7: see p.1, No. 10)
(SATA_8: see p.1, No. 9)
DUMMY
GND
GND
P+7
P-7
USB_PWR
P+6
P-6
USB_PWR
1
DUMMY
GND
GND
P+9
P-9
USB_PWR
P+8
P-8
USB_PWR
1
Infrared Module Header This header supports an
(5-pin IR1)
optional wireless transmitting
(see p.1 No. 22)
and receiving infrared module.
GND
IRRX
DUMMY
+5VSB
IRTX
1
SATA_5 SATA_6
SATA_3 SATA_4
SATA_7 SATA_8
SATA_1 SATA_2
USB 3.0 Header Besides two default USB 3.0
(19-pin USB3_2_3)
ports on the I/O panel, there is
(see p.1 No. 6)
one USB 3.0 header on this
motherboard. This USB 3.0
header can support two USB 3.0
ports.
1
IntA_PB_D+
Dummy
IntA_PB_D-
GND
IntA_PB_SSTX+
GND
IntA_PB_SSTX-
IntA_PB_SSRX+
IntA_PB_SSRX-
Vbus
Vbus
IntA_PA_SSRX-
IntA_P
A_SSRX+
GND
IntA_PA_SSTX-
IntA_P
A_SSTX+
GND
IntA_PA_D-
IntA_PA_D+