ASROCK H410M-ITX/ac - M.2 SSD Installation Guide

English
20
Addressable LED Header
(3-pin ADDR_LED1)
(see p.1, No. 5)
is header is used to connect
Addressable LED extension cable
which allows users to choose
from various LED lighting
eects.
Caution: Never install the
Addressable LED cable in the
wrong orientation; otherwise,
the cable may be damaged.
* Please refer to page 41 of our usr
manual for further instructions
on this header.
Chassis Intrusion Header
(2-pin CI1)
(see p.1, No. 18)
is motherboard
supports CASE OPEN
detection feature that
detects if the chassis cove
has been removed. is
feature requires a chassis
with chassis intrusion
detection design.
VOUT
DO_ADDR
GND
1
1
Signal
GND
2.7 M.2_SSD (NGFF) Module Installation Guide
The M.2, also known as the Next Generation Form Factor (NGFF), is a small size and
versatile card edge connector that aims to replace mPCIe and mSATA. The Ultra M.2
Socket (M2_1) supports M Key type 2280 M.2 SATA3 6.0 Gb/s module and M.2 PCI
Express module up to Gen3 x4 (32 Gb/s).
* Please be noted that if M2_1 is occupied by a SATA-type M.2 device, SATA3_0 will be
disabled.
Please refer to our user manual for details of M.2 module installation guide. For the latest
updates of the support list, please visit our website: http://www.asrock.com