To Next Page

To Previous Page

STEP 3: Use “RAID Installation Guide” to set RAID configuration.

Before you start to configure RAID function, you need to check the RAID installation

guide in the Support CD for proper configuration. Please refer to the BIOS RAID

installation guide in the following path in the Support CD:

.. \ RAID Installation Guide

STEP 4: Install Windows

XP / XP 64-bit OS on your system.

You can start to install Windows

XP / XP 64-bit OS on your system. At the beginning

of Windows

setup, press F6 to install a third-party RAID driver. When prompted,

insert the SATA / SATAII driver diskette containing the NVIDIA

RAID driver. After reading

the floppy disk, the drivers will be presented. Select the drivers to install. The drivers are

as below:

NOTE. If you install Windows

XP / XP 64-bit on IDE HDDs and want to manage

(create, convert, delete, or rebuild) RAID functions on SATA / SATAII HDDs, you still

need to set up “SATA Operation Mode” to [RAID] in BIOS first. Then, please set the

RAID configuration by using the Windows RAID installation guide in the following

path in the Support CD:

.. \ RAID Installation Guide

Please select A and B for Windows

XP / XP 64-bit in RAID mode. (There are two RAID

drivers needed for RAID mode, you have to select them separately. Please specify the

first RAID driver and then specify again for the second one.)

A. NVIDIA RAID Driver (required)

B. NVIDIA nForce Storage Controller (required)

ASROCK M3N78D User Manual

Other manuals for ASROCK M3N78D