ASROCK PHANTOM GAMING Z790 RIPTIDE WiFi - Page 42

38
ermistor Cable Header
(4-pin T_SENSOR1) (see p.7, No. 30)
e ermistor Cable Header is used to connect thermistor cable to monitor the
temperature of the critical components. Plug the thermistor cable that comes with the
package to this header, and then attach the sensor end to the component to detect its
temperature.
Connect your ermistor Cable to the
ermistor Cable Header ( T_SENSOR1) on
the motherboard.
T_SENSOR1
SENSOR IN
GND
1
T_SENSOR1