ASROCK RIPTIDE Z790 PG - Page 51

English
47
Z790 PG Riptide
Step 3
Before installing a M.2 SSD
module, please loosen the screws to
remove the M.2 heatsink.
*Please remove the protective lms
on the bottom side of the M.2
heatsink before you install a M.2
SSD module.
Step 4
Move the stando based on the
module type and length. e
stando is placed at the nut location
B by default. Skip Step 4 and 5 if
your M.2 SSD module is Type 2280.
Step 5
Peel o the yellow protective lm on
the nut to be used. Hand tighten the
stando into the desired nut location
on the motherboard.
Step 6
Align and gently insert the M.2 SSD
module into the M.2 slot. Please
be aware that the M.2 SSD module
only ts in one orientation.
1
1
2
AB
20
o
AB